• <optgroup id="gwcg8"><optgroup id="gwcg8"></optgroup></optgroup>
  • <xmp id="gwcg8">
    Products
     Home > NewsNews

    The relationship between the pulley rope groove and the wire rope

    View: 171305/23/2017  

    The relationship between the pulley rope groove and the wire rope


    The depth of groove should be selected so that the rope does not rub against the flange of the sheave or each other while entering running or leaving the groove. Angle of circular arc of the bottom of groove should not be less than 120 Degrees.

    The grooves on the drum should be pitched so that there is clearance between neighboring turns of rope on that drum. The recommended clearances are 1.5 mm up to rope diameter of 28 mm and 3 mm for rope diameter above 28 mm.

    The groove diameter of the pulley or sheave should always be larger then actual diameter of the rope. But if the groove diameter is too large the rope will tend to flatten and if it is too small pinching or rope will take place. The correct positioning is explained as under along with the tolerance and clearances on pully or sheave groove diameters.

    Related products
    Hot Rolling sheave
    Hot Rolling sheave
    Full forging sheave/solid sheave
    Full forging sheave/solid sheave
    Ring forging sheave
    Ring forging sheave
    Ring forging
    Ring forging
    View More(Total0)Comment Lists
    No Comment
    I want to comment
    Content *
    Verification Code*
    中文
    Hrvatska
    Fran?ais
    Italiano
    Português
    日本の
    ???
    ???????
    Deutsch
    ?esky
    Dansk
    Nederlands
    suomi
    Ελληνικ?
    ??????
    norsk
    Türkiye
    ?????????
    български
    русский
    Svenska
    Polski
    Roman?
    Vi?t Nam
    ewm
    中文字幕乱码免费